BS EN 13480-4: 2002 Metallic industrial piping - Part 4: Fabrication and installation (Eng)

78 стр. THIRD EDITION, NOVEMBER 2009 The intent of this code is to specify the in-service inspection and condition-monitoring program that is needed to determine the integrity of piping. That program should provide reasonably accurate and timely assessments to determine if any changes in the condition of piping could possibly compromise continued safe operation. It is also the intent of this code that owner-users shall respond to any inspection r...

American Petroleum Institute (API). First Edition. October 2004. 114p. This recommended practice (RP) provides guidance to the API authorized inspector on welding inspection as encountered with fabrication and repair of refinery and chemical plant equipment and piping. Common welding processes, welding procedures, welder qualifications, metallurgical effects from welding, and inspection techniques are described to aid the inspector in fulfilling...

This European Standard was approved by CEN on 23 May 2002. 58p. This European Standard specifies the requirements for materials (including clad materials) for unfired pressure vessels and supports which are covered by EN 13445-1:2002 and manufactured from metallic materials; it is currently limited to steels with sufficient ductility. This document is not applicable in the creep range.

This European Standard was approved by CEN on 23 May 2002. Amendment A1 was approved by CEN on 12 May 2005. 18p. This European Standard specifies the requirements for industrial piping systems and supports, including safety systems, made of metallic materials (but initially restricted to steel) with a view to ensure safe operation.

This European Standard was approved by CEN on 23 May 2002. 58p. This Part of this European Standard specifies the requirements for materials (including metallic clad materials) for industrial piping and supports covered by EN 13480-1 manufactured from of metallic materials. It is currently limited to steels with sufficient ductility. This Part of this European Standard is not applicable to materials in the creep range

This European Standard was approved by CEN on 23 May 2002. Amendment A1 was approved by CEN on 20 July 2005. 326p. This Part of this European Standard specifies the design and calculation of industrial metallic piping systems, including supports, covered by EN 13480.

This European Standard was approved by CEN on 23 May 2002. 36p. This Part of this European Standard specifies the requirements for inspection and testing of industrial piping as defined in EN 13480-1:2002 to be performed on individual spools or piping systems, including supports, designed in accordance with EN 13480-3 and prEN 13480-6 (if applicable), and fabricated and installed in accordance with EN 13480-4.

This European Standard was approved by CEN on 16 April 2004; amendment A1:2005 was approved by CEN on 22 September 2005. 38p. This document specifies requirements for industrial piping either totally buried or partly buried and partly run in sleeves or similar protection. It is used in conjunction with the other six parts of EN 13480

This European Standard was approved by CEN on 29 April 2002. 42p. This European Standard specifies the requirements for safety systems which protect a vessel, a system of vessels, piping, accessories or assemblies from exceeding operating conditions. It is also applicable to safety related indicators and alarms, signals and warning devices when used in safety systems.

17 стр. NACE International This standard establishes guidelines to prevent most forms of environmental cracking of weldments in carbon steel refinery equipment and piping. Weldments are defined to include the weld deposit, base metal HAZs, and adjacent base metal zones subject to residual stresses from welding. This standard covers only carbon steels classified as P-No. 1, Group 1 or 2. These classifications can be found in the ASME Boiler and Pr...