BS EN 13480-3: 2002+A1: 2005 Metallic industrial piping - Part 3: Design and calculation (Eng)

78 стр. THIRD EDITION, NOVEMBER 2009 The intent of this code is to specify the in-service inspection and condition-monitoring program that is needed to determine the integrity of piping. That program should provide reasonably accurate and timely assessments to determine if any changes in the condition of piping could possibly compromise continued safe operation. It is also the intent of this code that owner-users shall respond to any inspection r...

114 cтр. The European Standard EN 12516-1:2005 has the status of a British Standard This European Standard was approved by CEN on 15 March 2005. This document (EN 12516-1:2005) has been prepared by Technical Committee CEN/TC 69 Industrial valves, the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by October...

This European Standard was approved by CEN on 25 July 2001. 148p. This Part of this European Standard specifies the requirements for the design and calculation of water-tube boilers as defined in EN 12952-1.

This Part of this European Standard specifies requirements for the design and calculation of pressure parts of shell boilers as defined in EN 12953-1.

This European Standard was approved by CEN on 23 May 2002. 58p. This European Standard specifies the requirements for materials (including clad materials) for unfired pressure vessels and supports which are covered by EN 13445-1:2002 and manufactured from metallic materials; it is currently limited to steels with sufficient ductility. This document is not applicable in the creep range.

This European Standard was approved by CEN on 23 May 2002. Amendment A1 was approved by CEN on 12 May 2005. 18p. This European Standard specifies the requirements for industrial piping systems and supports, including safety systems, made of metallic materials (but initially restricted to steel) with a view to ensure safe operation.

This European Standard was approved by CEN on 23 May 2002. 58p. This Part of this European Standard specifies the requirements for materials (including metallic clad materials) for industrial piping and supports covered by EN 13480-1 manufactured from of metallic materials. It is currently limited to steels with sufficient ductility. This Part of this European Standard is not applicable to materials in the creep range

This European Standard was approved by CEN on 23 May 2002. 48p. This Part of this European Standard specifies the requirements for fabrication and installation of piping systems, including supports, designed in accordance with EN 13480-3.

This European Standard was approved by CEN on 23 May 2002. 36p. This Part of this European Standard specifies the requirements for inspection and testing of industrial piping as defined in EN 13480-1:2002 to be performed on individual spools or piping systems, including supports, designed in accordance with EN 13480-3 and prEN 13480-6 (if applicable), and fabricated and installed in accordance with EN 13480-4.

This European Standard was approved by CEN on 16 April 2004; amendment A1:2005 was approved by CEN on 22 September 2005. 38p. This document specifies requirements for industrial piping either totally buried or partly buried and partly run in sleeves or similar protection. It is used in conjunction with the other six parts of EN 13480