BS EN 764-3: 2002 Pressure equipment - Part 3: Definition of parties involved (Eng)

148 стр. EIGHTH EDITION, DECEMBER 2008 This standard applies to the sizing and selection of pressure relief devices used in refineries and related industries for equipment that has a maximum allowable working pressure of 15 psig (103 kPag) or greater. The pressure relief devices covered in this standard are intended to protect unfired pressure vessels and related equipment against overpressure from operating and fire contingencies. This standard...

This European Standard was approved by CEN on 20 January 2003. 18p. This European Standard specifies requirements for flat products for pressure equipment made of weldable fine grain steels as specified in Table 1.

This European Standard was approved by CEN on 20 February 2003. 16p. This European Standard specifies requirements for flat products for pressure equipment made of nickel alloy steels as specified in Table 1.

This European Standard was approved by CEN on 26 October 1997. Amendment A1 was approved by CEN on 14 March 2002. 18p. This Part of this European Standard specifies the general technical delivery conditions for open die steel forgings, ring rolled products and forged bars for pressure purposes

This Part of this European Standard specifies requirements for safety related equipment for shell boilers as defined in EN 12953-1, irrespective of the degree of supervisions.

This European Standard was approved by CEN on 23 May 2002. 60p. This document specifies requirements for the manufacture of unfired pressure vessels and their parts, made of steels, including their connections to non-pressure parts. It specifies requirements for material traceability, manufacturing tolerances, welding requirements, production tests, forming requirements, heat treatment, repairs and finishing operations.

This European Standard was approved by CEN on 23 May 2002, and amendment A1 was approved by CEN on 9 February 2004. 38p. This European Standard specifies requirements for the design, materials, manufacturing and testing of pressure vessels and pressure vessel parts intended for use with a maximum allowable pressure, PS, equal or less 50 bar and shell wall thicknesses not exceeding 60 mm, that are constructed of spheroidal graphite cast iron.

This European Standard was approved by CEN on 2 March 2004. 18p. This part of the European Standard defines the basic terminology and symbols to be used for pressure equipment addressed by the European Directive 97/23/EC with regard to pressure, temperature, volume and nominal size.

This European Standard was approved by CEN on 29 April 2002. 10p. This European Standard specifies the basic quantities, symbols and units to be used for pressure equipment and assemblies addressed by the European Directive 97/23/EC.

This European Standard was approved by CEN on 29 April 2002. 42p. This European Standard specifies the requirements for safety systems which protect a vessel, a system of vessels, piping, accessories or assemblies from exceeding operating conditions. It is also applicable to safety related indicators and alarms, signals and warning devices when used in safety systems.