BS EN 764-1: 2004 Pressure equipment - Part 1: Terminology - Pressure, temperature, volume, nominal size (Eng)

63 стр. THIRD EDITION, NOVEMBER 2009 This recommended practice (RP) covers the inspection of pressure vessels. It includes a description of the various types of pressure vessels (including pressure vessels with a design pressure below 15 psig) and the standards for their construction and maintenance. This RP also includes reasons for inspection, causes of deterioration, frequency and methods of inspection, methods of repair, and preparation of re...

148 стр. EIGHTH EDITION, DECEMBER 2008 This standard applies to the sizing and selection of pressure relief devices used in refineries and related industries for equipment that has a maximum allowable working pressure of 15 psig (103 kPag) or greater. The pressure relief devices covered in this standard are intended to protect unfired pressure vessels and related equipment against overpressure from operating and fire contingencies. This standard...

This European Standard was approved by CEN on 20 February 2003. 28p. This European Standard specifies requirements for flat products for pressure equipment made of weldable nonalloy and alloy steels with elevated temperature properties as specified in Table 1. The requirements and definitions of EN 10028-1 also apply.

This European Standard was approved by CEN on 20 February 2003. 16p. This European Standard specifies requirements for flat products for pressure equipment made of nickel alloy steels as specified in Table 1.

This European Standard was approved by CEN on 5 September 1999. 24p. This Part of this European Standard specifies the technical delivery conditions for forgings for pressure purposes, made of ferritic and martensitic steels with specified elevated temperature purposes

This European Standard was approved by CEN on 8 November 1998. 10p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes, made of nickel steels, for use at low temperatures.

This European Standard was approved by CEN on 23 May 2002, and amendment A1 was approved by CEN on 9 February 2004. 38p. This European Standard specifies requirements for the design, materials, manufacturing and testing of pressure vessels and pressure vessel parts intended for use with a maximum allowable pressure, PS, equal or less 50 bar and shell wall thicknesses not exceeding 60 mm, that are constructed of spheroidal graphite cast iron.

This European Standard was approved by CEN on 29 April 2002. 10p. This European Standard specifies the basic quantities, symbols and units to be used for pressure equipment and assemblies addressed by the European Directive 97/23/EC.

This European Standard was approved by CEN on 29 April 2002. 8p. This European Standard defines terms and definitions of parties involved in the design, manufacture, testing and inspection of pressure equipment and assemblies addressed by the European Directive 97/23/EC