API RP 578. Material Verification Program for New and Existing Alloy Piping Systems

American Petroleum Instltute (API) Fifth Edition, October. 1991. Reaffirmed June 2000. 62p. This document recommends minimum requirements and guidelines for the design and installation of new piping systems on production platforms located offshore

American Petroleum Instltute (API) Twenty-First Edition, December 2000, Errata and Supplement 1, December 2002. 242p. This publication serves as a guide for those who are concerned with the design and construction of new platforms and for the relocation of existing platforms used for the drilling, development, and storage of hydrocarbons in offshore areas

American Petroleum Instltute (API) Second Edition, November 2001. 246p. Process monitors that measure and transmit information about chemical composition, physical properties, or chemical properties are known as process analyzer systems. Many of these systems were first developed for laboratory analysis. Today they are primarily used as continuous on-line analyzers.

American Petroleum Instltute (API) Second Edition, September 2008. 654p. This publication provides quantitative procedures to establish an inspection program using risk-based methods for pressurized fixed equipment, including pressure vessel, piping, tankage, pressure relief devices, and heat exchanger tube bundles. This document is to be used in conjunction with API 580, which provides guidance on developing a riskbased inspection program for fi...

American Petroleum Instltute (API) Third Edition, May 2004. 52p. This recommended practice is intended to assist in development of a management program designed to promote safety and environmental protection during the performance of offshore oil and gas and sulphur operations.

American Petroleum Institute (API) Second Edition, March 2002. Effective Data, January 2005. 110p. These specifications establish design standards for systems, that are used to control blowout preventers (BOPs) and associated valves that control well pressure during drilling operations.

American Petroleum Instltute (API) Fourth Edition, April 1999. 240p. This international standard covers the minimum requirements for lubrication systems, oil-type shaft-sealing systems, dry gas face-type shaft-sealing systems, and controloil systems for general or special purpose applications

This standard American Welding Society (AWS). 1989. 14p. This Standard establishes minimum requirements for Test Facilities, their personnel, and equipment to qualify for accreditation to test and qualify welders in the AWS Certified Welder Program.

This standard American Welding Society (AWS). 1991. 12p. This Standard establishes minimum requirements for Test Facilities, their personnel, and equipment to qualify for accreditation to test and qualify welders in the AWS Certified Welder Program.

This standard American Welding Society (AWS). 1993. 24p. Supplement F of AWS QC7-93, Standard for AWS Certified Welders, was developed using as references ANSI/ASME B31.3, Chemical Plant and Petroleum Refinery Piping and ASME Boiler and Pressure Vessel Code, Section IX, Welding and Brazing Qualifications. American Welding Society makes no assessment of WPS or PQR compliance with either of these standards nor of their usability in production weldi...