BS EN 757: 1997 Welding consumables - Covered electrodes for manual metal arc welding of high strength steels - Classification (Eng)

This specification prescribes requirements for the classification of covered stainless steel electrodes for shielded metal arc welding.

This specification prescribes requirements for the classification of low-alloy steel electrodes for shielded metal arc welding of carbon and low-alloy steels.

This standard American Welding Society (AWS). 1997. 32p. This specification prescribes requirements for the classification of nickel and nickel-alloy covered electrodes for shielded metal arc welding. It includes those compositions in which the nickel content exceeds that of any other element.

This standard American Welding Society (AWS). 1990. 18p. This specification prescribes requirements for the classification of the following: (a) Rods for oxyfuel gas welding; (b) Electrodes for gas metal arc welding; (c) Electrodes for flux cored arc welding; (d) Electrodes for shielded metal arc welding.

This standard American Welding Society (AWS). 1997. 23p. This specification prescribes requirements for the classification of electrodes (both solid and composite metal cored) and fluxes for electroslag welding of carbon and low-alloy steels.

This European Standard was approved by CEN on 4 September 1999. 12 p. This standard specifies requirements for classification of wire electrodes, wires and rods for gas shielded metal arc welding, gas tungsten arc welding, plasma arc welding and submerged arc welding of stainless and heat resisting steels. The classification of the wire electrodes, wires and rods is based on their chemical composition.

This European Standard was approved by CEN on 2 January 2004. 16p. This standard specifies requirements for classification of electrode-flux combinations and all-weld metal in the as-welded condition for submerged arc welding of non alloy and fine grain steels with a minimum yield strength of up to 500 MPa. Classification can be made with solid wire electrodes or tubular cored electrodes. One flux may be classified with different electrodes. The...

This European Standard was approved by CEN on 1997-01-19. 16p. This standard specifies requirements for classification of tubular cored electrodes in the as-welded condition for metal arc welding with or without a gas shield of non-alloy and fine grain steels with a minimum yield strength of up to 500 N/mm2.

This European Standard was approved by CEN on 1996-02-12. 14p. This standard applies to fluxes for the submerged arc welding of non-alloyed, low alloy and high alloy steels such as stainless and heat resisting steels and of nickel and nickel alloys using wire electrodes and strip electrodes.