BS EN 760: 1996 Welding consumables - Fluxes for submerged arc welding - Classification (Eng)

Approved by the American National Standards Institute April 4, 2008, 40 p. This standard is a tool for communication between a purchaser and a supplier of welding consumables within quality systems as might, for example, be based upon ISO 9001. This standard, together with an AWS, ISO, or other recognized welding consumable standard, provides a method for preparing those specific details needed for welding consumable procurement which consist o...

This standard American Welding Society (AWS). 1997. 28p. This specification prescribes requirements for the classification of carbon steel electrodes (both solid and composite) and fluxes for submerged arc welding.

This standard American Welding Society (AWS). 1997. 34p. This specification prescribes requirements for the classification of low-alloy steel electrodes (both solid and composite) and fluxes for submerged arc welding.

This standard American Welding Society (AWS). 1997. 23p. This specification prescribes requirements for the classification of electrodes (both solid and composite metal cored) and fluxes for electroslag welding of carbon and low-alloy steels.

This standard American Welding Society (AWS). 1992. 10p. This specification prescribes requirements for the classification of brazing fluxes used with brazing or braze welding filler metals such as those classified in AWS A5.8.

This European Standard was approved by CEN on 4 September 1999. 12 p. This standard specifies requirements for classification of wire electrodes, wires and rods for gas shielded metal arc welding, gas tungsten arc welding, plasma arc welding and submerged arc welding of stainless and heat resisting steels. The classification of the wire electrodes, wires and rods is based on their chemical composition.

This European Standard was approved by CEN on 2 January 2004. 16p. This standard specifies requirements for classification of electrode-flux combinations and all-weld metal in the as-welded condition for submerged arc welding of non alloy and fine grain steels with a minimum yield strength of up to 500 MPa. Classification can be made with solid wire electrodes or tubular cored electrodes. One flux may be classified with different electrodes. The...

ESAB AB. Goteborg, Sweden. 2008. 96 p. This technical handbook gives detailed information of the extensive range of ESAB consumables for joining materials with the submerged arc welding process, along with general information associated with this process. Consumables for cladding and hardfacing are described in other documents available from ESAB.