API RP 2201 - 1995 Procedures for Welding or Hot Tapping on Equipment in Service (Eng)

70 стр. Downstream Segment American Petroleum Institute, Ninth Edition , June 2006 General Application Coverage This inspection code covers the in-service inspection, repair, alteration, and rerating activities for pressure vessels and the pressure- relieving devices protecting these vessels. This inspection code applies to all refining and chemical process vessels that have been placed in service unless specifically excluded per 1.2.2. This incl...

1128 стр. American Petroleum Institute, The American Society of Mechanical Engineers, JUNE 5, 2007, Second Edition The methods and procedures in this Standard are intended to supplement and augment the requirements in API 510, API 570, API 653, and other post construction codes that reference FFS evaluations such as NB-23. The assessment procedures in this Standard can be used for Fitness-For-Service assessments and/or rerating of equipment desig...

374 стр. American Petroleum Institute, The American Society of Mechanical Engineers, AUGUST 11, 2009 Fitness-For-Service (FFS) assessments in API 579-1/ASME FFS-1 Fitness-For-Service are engineering evaluations that are performed to demonstrate the structural integrity of an in-service component that may contain a flaw or damage or that may be operating under specific conditions that could produce a failure. API 579-1/ASME FFS-1 provides guidance...

American Petroleum Institute (API). First Edition. October 2004. 114p. This recommended practice (RP) provides guidance to the API authorized inspector on welding inspection as encountered with fabrication and repair of refinery and chemical plant equipment and piping. Common welding processes, welding procedures, welder qualifications, metallurgical effects from welding, and inspection techniques are described to aid the inspector in fulfilling...

67 стр. American Petroleum Institute, Second Edition, December, 1997 This specification is formulated to provide for the availability of safe and functionally interchangeable drill through equipment utilized for drilling for oil and gas. Technical content provides requirements for performance, design, materials, tests and inspection, welding, marking, handling, storing, and shipping. This specification does not apply to field use or field testing...

44 стр. FOURTH EDITION, APRIL 2009 ADDENDUM 1, AUGUST 2010 This standard covers steel storage tanks built to API 650 and its predecessor API 12C. It provides minimum requirements for maintaining the integrity of such tanks after they have been placed in service and addresses inspection, repair, alteration, relocation, and reconstruction. The scope is limited to the tank foundation, bottom, shell, structure, roof, attached appurtenances, and nozzl...

569 стр. An American National Standard Approved by the American National Standards Institute March 11, 2010 22nd Edition This code contains the requirements Tor fabricating and erecting welded steel structures. When this code is stipulated in contract documents, conformance with all provisions of the code shall be required, except for those provisions that the Engineer (see 1.4.1) or contract documents specifically modifies or exempts. The follow...

17 стр. NACE International This standard establishes guidelines to prevent most forms of environmental cracking of weldments in carbon steel refinery equipment and piping. Weldments are defined to include the weld deposit, base metal HAZs, and adjacent base metal zones subject to residual stresses from welding. This standard covers only carbon steels classified as P-No. 1, Group 1 or 2. These classifications can be found in the ASME Boiler and Pr...