ANSI/API Std 2015-2001 Requirements for Safe Entru and Cleaning of Petroleum Storage Tanks

This standard American Welding Society (AWS). 2005. 68p. This standard shall be for the guidance of educators, ooerators, managers, and supervisors in the safe setup and use of welding and cutting equipment, and the safe performance of welding and cutting operations.

American Petroleum Instltute (API) Fourth Edition, June 1999. 104p. This document recommends minimum requirements and guidelines for the design and installation of electrical systems on fixed and floating petroleum facilities located offshore

American Petroleum Instltute (API) First Edition, September 2006. 127p. This document recommends minimum requirements and guidelines for the design and installation of electrical systems on fixed and floating petroleum facilities located offshore when hazardous locations are classified as Zone 0, Zone 1, or Zone 2.

American Petroleum Instltute (API) Twenty-First Edition, December 2000, Errata and Supplement 1, December 2002. 242p. This publication serves as a guide for those who are concerned with the design and construction of new platforms and for the relocation of existing platforms used for the drilling, development, and storage of hydrocarbons in offshore areas

American Petroleum Instltute (API) Second Edition, May 2006. 106p. The purpose of these recommended practices is to provide information that can serve as a voluntary industry guide for safe well control operations. This publication is designed to serve as a direct field aid in well control and as a technical source for teaching well control principles.

American Petroleum Instltute (API) First Edition, October 2001, Reaffirmed, March 2007. 36p. The purpose of this document is to recommend practices and procedures for promotion and maintenance of safe working conditions for personnel engaged in onshore oil and gas production, including special services.

American Petroleum Institute (API) Fifth Edition, June 2001. 30p. The following definitions are applicable to underground tank lining and inspection as described in this standard.

American Petroleum Instltute (API) Third Edition, January 1982. 18p. This standard covers the normal and emergency venting requirements for aboveground liquid petroleum storage tanks and aboveground and belowground refrigerated storage tanks designed for operation at pressures form 1/2 ounce per square inch vacuum through 15 pounds inch gage.

American Petroleum Instltute (API) Fourth Edition, April 2009. 166p. This standard covers steel storage tanks built to API 650 and its predecessor API 12C. It provides minimum requirements for maintaining the integrity of such tanks after they have been placed in service and addresses inspection, repair, alteration, relocation, and reconstruction.

This standard American Welding Society (AWS). 1993. 24p. Supplement F of AWS QC7-93, Standard for AWS Certified Welders, was developed using as references ANSI/ASME B31.3, Chemical Plant and Petroleum Refinery Piping and ASME Boiler and Pressure Vessel Code, Section IX, Welding and Brazing Qualifications. American Welding Society makes no assessment of WPS or PQR compliance with either of these standards nor of their usability in production weldi...