Статья. Опубликована в журнале "J. Wear". – 2001. – Vol.
250. – P. 384-390. Авторы: V.K. Jain, P. Kumar, P.K. Behera, S.C. Jayswal. Статья на английском языке. Название на русском языке: Влияние рабочего зазора и окружной скорости на выполнение магнитно-абразивной финишной обработки. Аннотация к статье на английском языке:
Magnetic abrasive finishing (MAF) is one of the advanced finishing processes in which workpiece is kept between two magnets, and cutting force is controlled by working gap and magnetic field between the two magnets. MAF setup is designed for finishing cylindrical workpieces and it is mounted on lathe machine. The loosely bounded powder is prepared for experimentation by homogeneous mixing of magnetic powder (Fe powder of 300 mesh size (51.4 µm)), abrasive powder (Al2O3 of 600 mesh size (25.7 µm), and lubricant called servospin-12 oil. To investigate the effects of working gap and circumferential speed on material removal, change in surface finish and percent improvement in surface finish, a series of experiments have been conducted using in-house fabricated setup. Based upon the results, in general, material removal decreases by increasing working gap or decreasing circumferential speed of the workpiece. Change in surface finish increases by increasing circumferential speed of the workpiece.
250. – P. 384-390. Авторы: V.K. Jain, P. Kumar, P.K. Behera, S.C. Jayswal. Статья на английском языке. Название на русском языке: Влияние рабочего зазора и окружной скорости на выполнение магнитно-абразивной финишной обработки. Аннотация к статье на английском языке:
Magnetic abrasive finishing (MAF) is one of the advanced finishing processes in which workpiece is kept between two magnets, and cutting force is controlled by working gap and magnetic field between the two magnets. MAF setup is designed for finishing cylindrical workpieces and it is mounted on lathe machine. The loosely bounded powder is prepared for experimentation by homogeneous mixing of magnetic powder (Fe powder of 300 mesh size (51.4 µm)), abrasive powder (Al2O3 of 600 mesh size (25.7 µm), and lubricant called servospin-12 oil. To investigate the effects of working gap and circumferential speed on material removal, change in surface finish and percent improvement in surface finish, a series of experiments have been conducted using in-house fabricated setup. Based upon the results, in general, material removal decreases by increasing working gap or decreasing circumferential speed of the workpiece. Change in surface finish increases by increasing circumferential speed of the workpiece.