BS EN 10028-7: 2000 Flat products made of steels for pressure purposes - Part 7: Stainless steels (Eng)

This European Standard was approved by CEN on 29 October 1999. Amendment A1 was approved by CEN on 16 October 2002. 24p. This European Standard EN 10028-1 specifies the general technical delivery conditions for flat products used principally for the construction of pressure equipments. The general technical delivery conditions in EN 10021 also apply to products supplied in accordance with this European Standard.

This European Standard was approved by CEN on 20 February 2003. 28p. This European Standard specifies requirements for flat products for pressure equipment made of weldable nonalloy and alloy steels with elevated temperature properties as specified in Table 1. The requirements and definitions of EN 10028-1 also apply.

This European Standard was approved by CEN on 20 January 2003. 18p. This European Standard specifies requirements for flat products for pressure equipment made of weldable fine grain steels as specified in Table 1.

This European Standard was approved by CEN on 20 February 2003. 16p. This European Standard specifies requirements for flat products for pressure equipment made of nickel alloy steels as specified in Table 1.

This European Standard was approved by CEN on 17 January 2003. 18p. This European Standard specifies the requirements for flat products for pressure equipments made of thermomechanically rolled steels as specified in Table 1.

This European Standard was approved by CEN on 17 January 2003. 16p. This European Standard specifies the requirements for flat products for pressure equipments made of quenched and tempered steels as specified in Table 1. The requirements in EN 10028-1 also apply.

This European Standard was approved by CEN on 5 September 1999. 24p. This Part of this European Standard specifies the technical delivery conditions for forgings for pressure purposes, made of ferritic and martensitic steels with specified elevated temperature purposes

This European Standard was approved by CEN on 8 November 1998. 10p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes, made of nickel steels, for use at low temperatures.

This European Standard was approved by CEN on 8 November 1998. Amendment A1:2000 was approved by CEN on 20 April 2001. 12p. This part of this European Standard specifies the technical delivery conditions of the types of forgings for pressure purposes, made of weldable fine-grain steels with high proof strength.

This European Standard was approved by CEN on 3 September 1999. 20p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes made of stainless steels, including creep resisting steels.