BS EN 10025-1: 2004 Hot rolled products of structural steels - Part 1: General technical delivery conditions (Eng)

This European Standard was approved by CEN on 25 November 2006. 20p. This European Standard specifies the general technical delivery conditions for all steel products covered by EN 10079 with the exception of steel castings and powder metallurgical products.

This European Standard was approved by CEN on 1 April 2004. 38p. This European Standard specifies the technical delivery conditions for flat and long products and semi-finished products which are meant for further processing to flat and long products of hot rolled non-alloy quality steels in the grades and qualities given in Tables 2 to 6 (chemical composition) and Tables 7 to 9 (mechanical properties) in the delivery conditions as given in 6.3....

This European Standard was approved by CEN on 1 April 2004. 28p. This European Standard specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the normalized/normalized rolled delivery condition in the grades and qualities given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical properties) in thickness ? 250 mm for grades S275, S355 and S420 and in thickness ? 200 mm for grade...

This European Standard was approved by CEN on 1 April 2004. 28p. This European Standard specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the thermomechanical rolled condition in the grades and qualities given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical properties) in thickness ? 120 mm for flat products and in thickness ? 150 mm for long products

This European Standard was approved by CEN on 1 April 2004. 30p. This document, in addition to Part 1, specifies requirements for flat and long products of hot rolled steels with improved atmospheric corrosion resistance in the grades and qualities given in Tables 2 and 3 (chemical composition) and Tables 4 to 5 (mechanical properties) in the usual delivery conditions as given in 6.3

This European Standard was approved by CEN on 1 April 2004. 28p. This European Standard specifies requirements for flat products of high yield strength alloy special steels. The grades and qualities are given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical properties) and are supplied in the quenched and tempered condition as given in 6.3.

This European Standard was approved by CEN on 29 October 1999. Amendment A1 was approved by CEN on 16 October 2002. 24p. This European Standard EN 10028-1 specifies the general technical delivery conditions for flat products used principally for the construction of pressure equipments. The general technical delivery conditions in EN 10021 also apply to products supplied in accordance with this European Standard.

This European Standard was approved by CEN on 1 November 2002. 36p. This European Standard specifies the technical delivery requirements for round and flat bars, ribbed and grooved bars and rod manufactured from the alloy steels listed in Table 3, intended for hot-formed and subsequently heat-treated springs or cold-formed and subsequently heat-treated springs. The products are supplied in one of the heat-treatment conditions given for the differ...

This European Standard was approved by CEN on 26 October 1997. Amendment A1 was approved by CEN on 14 March 2002. 18p. This Part of this European Standard specifies the general technical delivery conditions for open die steel forgings, ring rolled products and forged bars for pressure purposes

This European Standard was approved by CEN on 3 September 1999. 20p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes made of stainless steels, including creep resisting steels.