AWS B5.17: 2004 Specification for the Qualification of Welding Fabricators (Eng)

This standard American Welding Society (AWS). 1990. 18p. This specification prescribes requirements for the classification of the following: (a) Rods for oxyfuel gas welding; (b) Electrodes for gas metal arc welding; (c) Electrodes for flux cored arc welding; (d) Electrodes for shielded metal arc welding.

Approved by the AWS Board of Directors 2009, 202p. This publication is an extract of AWS B2.1, Specification for Welding Procedure and Performance Qualification, and is identical to Annex D, Base Metal Grouping, in the 2009 edition of that standard. This publication supersedes AWS B2.1-BMG:2005.

This standard American Welding Society (AWS). 2010. 24p. This specification establishes the requirements for qualification of radiographic interpreters. It describes how these personnel shall be qualified, establishes training requirements, defines experience requirements, and establishes areas and levels of knowledge required to perform the functions related to radiographic interpretation.

This standard American Welding Society (AWS). 2006. 22p. This specification establishes qualification requirements for Welding Engineers. It describes how qualifications are determined, and the practice by which qualification may be attained and maintained.

This standard American Welding Society (AWS).2003. 22p. This standard establishes the requirements for qualification and defines the body of knowledge for welding inspection personnel.

This standard American Welding Society (AWS). 2005. 24p. This specification defines minimum requirements to enable welder qualification test facilities to consistently conduct welder qualification testing to meet the requirements of codes and other standards.

This standard American Welding Society (AWS). 2011. 22p. This specification establishes the attributes required for determining the qualification of welding educators.

This standard American Welding Society (AWS). 2006. 20p. This standard establishes requirements for the qualification of Welding Supervisors. It describes how personnel are qualified, the principles of conduct, and the practice by which qualification may be maintained.

This European Standard was approved by CEN on 14 October 2004. 26p. This document applies to welding consumables for which supplementary qualification is required. It contains the technical requirements to be fulfilled.